4.2 Controlling the direction of the motor
1. Activating dead man operation (DIP switch 7: “ON”).
2. Press the Open (1) or Close (3) button. The action of the door
must correspond to the respective command.
If the door runs in the opposite direction:
• disconnect the control unit from the mains;
• switch the lines on terminals 6 and 7.
4.3 Setting the motor limit switches
For more information on limit switches and how to set them, please
refer to the motor operating instructions.
1. Press and hold the Open (1) or Close (3) button until the door
reaches the end position.
2. If necessary, set the limit switch on the motor.
3. Repeat steps 1 and 2 for the other direction.
4. Deactivating dead man operation (DIP switch 7: “OFF”).
To Next Page
Loading...