SOMMER RDC vision - Page 22

22
4.6 Programming the handheld transmitter button to pulse mode
1. PressandholdtheRadiobutton(2)forapprox.0.5seconds.
Ö The radio LED (3) lights up, programming mode starts.
2. Pressthedesiredbutton(1)onthehandheldtransmitter.
Ö The radio LED (3) goes out. This button on the handheld transmitter is
programmedasthePulsebutton.Thecommandsequenceis:Open-Stop-
Close-Stop-etc.
If no radio signal is sent within 10 seconds of the start of programming mode,
programming mode is terminated; the radio LED (3) goes out.
4.7 Closing the housing cover
On completion of commissioning, close the housing cover and install the lamp cover.
2
1
“clic”
3