VPXT6R / VPXT6R SST
CUT-OUT TEMPLATE
1. Perform an obstruction survey to be certain that
there are no joists, conduit, pipes, heating ducts,
high-voltage electrical wires, gas lines, pocket doors,
or air returns in the walls or ceiling cavities that will
interfere with the speaker.
2. Position this cut-out template at the speaker location,
then pencil an outline on the ceiling.
3. Cut the mounting hole using a keyhole or drywall saw.
4. Proceed with installation.
NOTE: Please see the manual for detailed instructions
at www.sonance.com
To Previous Page
Loading...
