19810016 REV C Standard and iCLASS Enhanced Keypad
Page 5
4. Continue through the list and either clear the violation, by securing the door, window, etc. in
violation or bypass each violation.
Note: If the BYPASS option is used in any monitored device that failed to clear, it is recommended
that it be reported to the Central Station.
Note: If your system is scheduled to Arm Automatically and fails to do so, there is a device in
violation somewhere within your facility. The keypad’s event history displays the activity in order of
occurrence, starting with the most recent event. Once you clear the violations, your system will
allow you to arm.
2.5 Invalid Keypad Entry
When prompted to enter your Access Code, the screen does not change until after you have
pressed ENTER. If an invalid code is entered, the screen will display the following message:
UNABLE TO VERIFY
Press the <CLR (back) button to return to the Armed, Disarmed, or Occupied default screen.
Three attempts to enter a valid code are allowed, then the keypad will display message:
PLEASE STANDBY
The user interface will lock-out for two minutes.
2.6 Emergency 911 and Duress Codes
1. If 911 is enabled, the user can press 911 and then press ENTER if an emergency occurs.
Note: Pressing 911 will NOT contact the Police Department. However, it will send an
Emergency Duress Alarm to the Central Station.
911 will NOT be enabled for UL Listed Applications.
2. If a duress code is enabled, the user can press the ARM/DISARM button enter the duress code
and press ENTER to alert the monitoring center of duress while changing the state of the
partition from ARMED to DISARMED or from DISARMED to ARMED.
3. If duress occurs and the partition’s state does not need to be changed, the user can just enter
the duress code and press ENTER. The Monitoring Center will be alerted of the duress but the
partition will remain in its current state.
2.7 Accessing the System Menus
1. With the keypad displaying DISARMED on OCCUPIED - INSTANT or OCCUPIED - DELAYED,
key in an access code and press the ENTER or for iClass keypads you can swipe your card. The
system menus will then be displayed.
2. Use the navigation buttons to scroll through the various menus and press ENTER to make your
selection.
To Next Page
Loading...