test
PAIRING WITH YOUR DEVICE
Pairing with a smartphone / mobile / PDA etc.
Pairing procedures are subject to different makes and model of mobile phone. Please
refer to your mobile phone user’s manual for further information.
The general pairing procedures are as follows:
1. Place the headset and Bluetooth phone where they are easily viewable by no
more than 1 meter apart
2. Enter the headset’s pairing mode (please refer to “How to enter pairing mode”)
3. Activate your mobile phone’s Bluetooth function and set your phone to search for
Bluetooth devices within range, and select “X-FIT” from the list of devices shown
4. If prompted to enter a password or PIN. enter “0000”
5. If prompted by your mobile phone to connect, select “Yes” (this will vary among
mobile phone models)
6. After successfully connecting, the blue LED ashes two or three times every 4
seconds
You should now be able to listen to music as well as make and receive a call using the
headset.
Notes:
• If pairing fails, please turn off the headset rst and then re-pair according to
steps 1-6 mentioned above.
• After pairing is successful, the headset and the mobile phone will remember
each other, they will not need to re-pair next time. The headset can remember 8
paired devices. When the number of paired devices exceeds 8, the rst one will
be replaced
• Every time the headset is turned on, it will connect to last connected device
automatically. If you want to pair it with other devices, please turn off the
Bluetooth function of last connected devices rst and pair the headset with the
new device according to steps 1-6 mentioned above.
To Next Page