Sonnet
MORPHEUS
Connecting
Caution! Please connect your interconnects first before connecting the mains power cable!
Power requirements: Check if the product is made conform the power requirements of your area. On the back side the product is marked for
the specific mains voltage.
Optical input: Use an optical (Toslink) cable to use the optical input. The optical input can be used for sampling rates up to 96 kHz.
Coaxial input: A 75 Ohm coaxial cable should be used to connect the dac to other digital equipment. To avoid ground loops it has a galvanic
isolation and can handle a maximum sample rate of 192 kHz
To Next Page
Loading...