Sonoff DIY D1 - Button and Remote Functions; Basic On;Off Control; Brightness Level Adjustment; Device Pairing and Reset

SONOFF TECHNOLOGIES CO., LTD.
English
Buttons
Functions
On
Off
Short press for the low brightness, long press
to turn down the brightness
Short press for the medium brightness, long
press to turn down the brightness
Short press for the higher brightness, long
press to turn up the brightness
Short press for the high brightness, long press
to turn up the brightness
Long press for 5s until you hear “Bi Bi” and
release, then the remote controller is cleared
successfully. If you need to use, short press
any button within 5s after powering on again
and you will hear “Bi” , which indicates the
remote controller is paired successfully.
Long press for 5s until the connected light
enters the breathing mode, which indicates
the device enters quick pairing mode (Touch),
then you can add the light on eWeLink APP.
In quick pairing mode, you can short press
any button on the remote controller to exit this
mode.
3