EasyManuals Logo
Home>Sonoff>Switch>SNZB-01P

Sonoff SNZB-01P User Manual

Sonoff SNZB-01P
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
Warning
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2.Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for
help.
FCC Radiation Exposure statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of
20 cm between the radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
13
Reset the device to factory settings by "Delete device" in the eWeLink App.
Factory Reset

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sonoff SNZB-01P and is the answer not in the manual?

Sonoff SNZB-01P Specifications

General IconGeneral
Operating temperature (T-T)-10 - 60 °C
Operating relative humidity (H-H)5 - 95 %
ZigBeeYes
Ethernet LANNo
USB ports quantity-
Security algorithms128-bit AES
Connectivity technologyWireless
Control typeButtons
Product colorWhite
Housing materialPolycarbonate (PC)
Battery life5 year(s)
Number of batteries supported1
Package depth48 mm
Package width46 mm
Package height24 mm
Weight and Dimensions IconWeight and Dimensions
Width45 mm
Height17.7 mm
Weight27.7 g

Related product manuals