Sonos Controller Quick Setup Instructions
Before You Begin
You should charge your new Sonos Controller when you remove it from the packaging.
The Controller battery will be fully charged in about two (2) hours. You can use your
Controller while it is charging.
1. Pull up from the left side of the power connector cover on your Sonos Controller.
(This cover is part of your Controller’s splash-resistant design so keep the cover
down when the Controller is not charging).
2. Connect the AC power adapter to your Controller using the supplied cable.
3. Plug the power cord into the AC power adapter inlet as shown.
4. Plug the other end of the power cord into your electrical outlet.
You can continue to set up your music system while the Controller is charging.
Caution Use only the supplied power adapter to charge the Controller’s battery.
Using another adapter will damage your Controller and void your product warranty.
Power
connector
cover
AC power adapter
AC power
adapter
inlet
Power
cord
3
HHpl atter.fm Page 4 Wednesday, December 1, 2004 10:17 AM
To Next Page
Loading...
