Sonos ZonePlayer 90 Setup Guide
14
• If you are adding a ZoneBridge, attach the power adapter.
If you need help with this step, refer to the Setup Guide packaged with your Sonos
component, or start your Desktop Controller software and select Sonos System
Help from the Help menu.
2. If you are making a wired connection, connect an Ethernet cable from your router,
another ZonePlayer or ZoneBridge, or a live network wall plate (if you have built-in
wiring) to one of the Ethernet switch connections on the back of the new Sonos
component. If you are making a wireless connection, skip this step.
3. Attach the power cord and plug in the ZonePlayer or ZoneBridge.
4. Choose one of the following options:
•Using the Sonos Controller, select System Settings→Add a ZonePlayer or
ZoneBridge from the Music menu and follow the prompts to add this compo-
nent to your Sonos Multi-room Music System.
•Using the Desktop Controller software, select Zones→Add a ZonePlayer or
ZoneBridge and follow the prompts to add this component to your Sonos
Multi-room Music System.
Add a Controller
You should charge your new Sonos Controller when you remove it from the packaging.
Plug it into the power adapter, and then follow the Controller’s on-screen prompts to
add it to your music system (you can use the Controller while it is charging.)
To Next Page
Loading...
