Sonos ZonePlayer 90 - Adding to an Existing Sonos System; Where to Begin

Sonos ZonePlayer 90 Setup Guide
2
Where to Begin
New to Sonos?
It takes just a few steps to get your Sonos Multi-room Music System up and running (the
steps below are fully explained beginning on page 5) —
Connect a ZonePlayer or a ZoneBridge (purchased separately) to your
broadband router using an Ethernet cable (supplied). If you purchased a
Sonos ZoneBridge, please refer to the setup guide packaged with your
ZoneBridge for detailed instructions.
Place the other ZonePlayer(s) in the room(s) of your choice.
Install the software and follow the prompts to add the ZonePlayer(s) and set
up access to your music files.
Add the Controller to your music system.
See page 4 to make sure your home network is ready for Sonos, and then turn to page 5
for installation instructions. Once you’ve set up your music system, it’s easy to add
additional Sonos components any time.
Adding to an existing Sonos system?
If you are adding this Sonos component to an existing Sonos system, you can turn
directly to page 13.
1
2
3
4