Sonos ZonePlayer 90 Setup Guide
20
Controlling the volume from your Sonos system
1. Adjust your home theater or amplifier’s volume to typical listening volume.
2. If the line-out level on this ZonePlayer is not currently set to Variable, you will need
to change it:
• Using the Sonos Controller, from the Music menu, select System Settings. Select
ZonePlayer Settings, and use the scroll wheel to highlight the ZonePlayer
attached to the receiver. Select Line-Out Level, and choose Variable.
• Using the Desktop Controller software, select ZonePlayer Settings from the
Zones menu. Select the ZonePlayer attached to the receiver, and then click
Settings. Click the Line-Out tab, and choose Variable.
3. Use the Sonos Controller to adjust the volume on your Sonos system so you can
hear music. This may be at the high end of the volume scale.
4. If desired, you can readjust the volume on your home theater system or amplifier so
that the volume range for the Controller falls within your typical listening range.
Connecting to a computer or powered speakers
• If you are connecting to your computer: You will need a stereo mini to RCA Y-
adapter audio cable (one 1/8-inch stereo miniplug to dual RCA male connectors)
to connect the ZonePlayer’s analog audio output to the computer’s audio input.
• If you are connecting to powered speakers: You may need a Y-adapter audio cable
Note: When you change the line-out level to Fixed on your ZonePlayer
90, you will not be able to adjust the volume or the equalization settings
using your Sonos Controller.
To Next Page
Loading...
