Sonos ZP100
3
1-2-3 Setup
Connect Speakers and Apply Power
Speakers: Power rating should be at least 75W for 8 Ohm speakers and at least 150W for 4 Ohm speakers.
• Use your thumb or finger to firmly push the spring-loaded speaker connector post inward to reveal the connection hole.
• Insert the stripped end of the speaker wire into the hole, then release. Repeat for the other speaker connections.
• Attach the power cable and plug in your ZP100.
Important: Be sure to connect the red ( + ) and black ( - ) terminals from each
speaker to the corresponding terminals on the ZP100. Mismatching of polarities will
result in weak central sound, and a distorted sense of sound direction.
Important Note:Make sure the voltage switch is set to the proper position for your
household before plugging in your ZP100.
To Next Page
Loading...
