User Guide
4
Connect First ZP100
Connect a standard Ethernet cable (supplied) from any of the four (4) Ethernet switch connectors on the back of your ZP100
to an open port on your router (see A in the diagram below). Do not connect the ZP100 directly to your cable or DSL modem
unless your modem has a built-in router.
• If you don’t have a router, go to http://faq.sonos.com/norouter for instructions.
• If you don’t have an open port on your router, you can disconnect your computer from the router and connect it to the
ZP100 instead. Then connect the ZP100 into the router port the computer was previously plugged into.
Proceed to step 2 when the status indicator on the Sonos
component’s front panel flashes white and the Mute button flashes
green.
Important: The first Sonos component you install must connect to your home
network using a standard Ethernet cable (supplied).
If you prefer to use this ZP100
wirelessly, you can connect a SONOS BRIDGE to your router instead.
Mute button (green)
Status Indicator (white)
To Next Page
Loading...
Need help?
General
