Sonos ZonePlayer ZP80 - Initial System Setup; Step-by-Step Installation Guide

Sonos ZonePlayer ZP80 Setup Guide
4
1-2-3 Setup
IF you are setting up a new Sonos system
Attach the power cord and plug in the ZonePlayer ZP80.
Connect a standard Ethernet cable (supplied) from either of the two (2) Ethernet switch
connectors on the back of your ZonePlayer ZP80 to an open port on your router (see A in
the diagram below). Do not connect the ZonePlayer directly to your cable or DSL modem
unless your modem has a built-in router.
• If you don’t have a router, go to http://faq.sonos.com/norouter for instructions.
• If you don’t have an open port on your router, you can disconnect your computer from
the router and connect it to the ZonePlayer ZP80 instead. Then connect the ZonePlayer
Note: The first ZonePlayer you install must connect to your home network using a
standard Ethernet cable (supplied). If you should experience any difficulty during
the setup process, please go to www.sonos.com/support for additional help.
1
2
If you have
structured (built-in)
wiring, connect the
Ethernet cable into a
live wall plate (see B
in the diagram).