EasyManuals Logo

Sonotec SONAPHONE RD User Manual

Sonotec SONAPHONE RD
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
________________________________________________________________________________________________________________________________________________________________
BA_SPHRD_engl_080129 page 14
Charging the batteries
If the operating time of the SONAPHONE T runs out, the green lamp
sparkles and you have to recharge the internal batteries. To start
charging, you have to connect the plug of the charger with the
SONAPHONE T (plug CHARGE). After that you have to plug in the
charger. The red charging lamp CHARGE sparkles during charging. If
the accumulator is completely discharged it can take approximately 14
hours for recharging. When charging is completed, the red charging
lamp permanently lights up and the charger can be unplugged.
An overcharging protection in the device prevents a device damage
caused by overcharging. The charger can also be used as a power
adaptor for the SONAPHONE T.
CAUTION!
Only use the delivered charger to charge the internal batteries!

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sonotec SONAPHONE RD and is the answer not in the manual?

Sonotec SONAPHONE RD Specifications

General IconGeneral
BrandSonotec
ModelSONAPHONE RD
CategoryMeasuring Instruments
LanguageEnglish