To Next PageTo Next Page
Need help?Do you have a question about the Sonus SBC 1000 and is the answer not in the manual?
Provides definitions for technical terms used in the configuration guide.
Introduces the Sonus SBC 1000/2000 and its role with Lync 2013.
Identifies the target technical audience for this configuration guide.
Lists the specific Sonus and third-party equipment and software used for testing.
Describes the simulated enterprise site and network topology for testing.
Illustrates the connection diagram between Lync 2013, SBC 1000, and Windstream.
Details configuration steps for the SBC's connection to the external network.
Configures physical and logical Ethernet interfaces on the SBC for external connections.
Configures SIP communication parameters, timers, and headers for external devices.
Specifies voice codecs and media settings for call quality on external connections.
Defines specific voice codec configurations like G.711 and G.729 for external use.
Configures SIP server details and transport parameters for external device communication.
Defines static routes for IP traffic to external gateways.
Groups telephony channels for routing and shared configuration for external connections.
Configures rules for routing calls between signaling groups and external protocols.
Modifies names and numbers for routing external calls.
Configures authentication and registration for external SIP trunk connections.
Details configuration steps for the SBC's connection to the internal Lync network.
Configures physical and logical Ethernet interfaces for the internal network connection.
Configures SIP communication parameters, timers, and headers for internal devices.
Specifies voice codecs and media settings for call quality on internal connections.
Defines specific voice codec configurations like G.711 and G.729 for internal use.
Groups telephony channels for routing and shared configuration for internal connections.
Configures SIP server details for internal communication.
Configures rules for routing calls from Lync to the external network.
Modifies names and numbers for routing internal calls.
Covers the settings and procedures for integrating Lync Server 2013 with the SBC.
Adds the SBC as a Gateway device within the Lync Server Topology Builder.
Configures Lync Server routing to direct calls via the SBC to the SIP Trunk.
Covers initial setup procedures for all call types between SBC and Lync.
Maps preconfigured Lync extensions to established Windstream SIP Trunk DIDs.
Defines the normal calling pattern, including E.164 format for national and international calls.
Details the configuration for enabling SIP REFER method for call transfers.
Enables SIP REFER support on the SBC trunk configuration for call transfers.
Details the configuration for enabling call transfers using the Re-INVITE method.
Supports call transfers via RFC3261 method by setting REFER support to 'none'.
General| Brand | Sonus |
|---|---|
| Model | SBC 1000 |
| Category | Controller |
| Language | English |
