Sony BDP-S780 - Audio Settings

28
Audio Settings
Audio (HDMI)
Auto: Normally select this. Outputs audio
signals according to the status of the
connected HDMI device.
PCM: Outputs PCM signals from the HDMI
OUT jack.
DSD Output Mode
On: Outputs DSD signals from the HDMI
OUT jack when playing a Super Audio
CD. When “On” is selected, no signal is
output from other jacks.
Off
: Outputs PCM signals from the HDMI
OUT jack when playing a Super Audio
CD.
BD Audio MIX Setting
On: Outputs the audio obtained by mixing the
interactive and secondary audio to the
primary audio.
Off: Outputs the primary audio only. Select
this to output HD audio signals to an AV
amplifier (receiver).
Dolby Digital
Downmix PCM: Converts to output Linear
PCM signals. Select this when
connecting an audio device without a
built-in Dolby Digital decoder.
Dolby Digital
: Select this when connecting
an audio device with a built-in Dolby
Digital decoder.
DTS
Downmix PCM: Converts to output Linear
PCM signals. Select this when
connecting to an audio device without a
built-in DTS decoder.
DTS
: Select this when connecting to an audio
device with a built-in DTS decoder.
DTS Neo:6
Cinema: Outputs the simulated multi-channel
sound from 2 channel sources via the
HDMI OUT jack according to the
capability of the connected device using
“DTS Neo:6 Cinema” mode.
Music: Outputs the simulated multi-channel
sound from 2 channel sources via the
HDMI OUT jack according to the
capability of the connected device using
“DTS Neo:6 Music” mode.
Off
: Outputs the sound with its original
number of channels via the HDMI OUT
jack.
Audio DRC
Auto: Performs playback at the dynamic
range specified by the disc (BD-ROM
only). Other discs are played back at the
“On” level.
On: Performs playback at a standard
compression level.
Off: No compression works. A more dynamic
sound is produced.
Downmix
Surround: Outputs audio signals with
surround effects. Select this when
connecting an audio device that supports
Dolby Surround (Pro Logic) or DTS
Neo:6.
Stereo
: Outputs audio signals without
surround effects. Select this when
connecting an audio device that does not
support Dolby Surround (Pro Logic) or
DTS Neo:6.