You can adjust the output timing of the picture and sound. For details about supported
models, refer to the support site.
Support Site
Related topics
Adjusting the AV sync setting
Adjusting an audio system
[143] Sound | Sound
No TV sounds such as operation sound or audio
response.
If the TV is connected via eARC or [Pass through mode] is set to [Auto], TV sounds such
as those from remote control operation or voice responses are not output because audio
signals from the HDMI input are passed through to the eARC audio system. To output
those sounds from the TV, try the following.
Stop watching the HDMI input device.
Set [eARC mode] to [Off].
Press the (Quick Settings) button on the remote control, then select [Settings] —
[Display & Sound] — [Audio output] — [eARC mode] — [Off].
Set [Pass through mode] to [Off].
Press the (Quick Settings) button on the remote control, then select [Settings] —
[Display & Sound] — [Audio output] — [Pass through mode] — [Off].
[144] Sound | Sound
You cannot establish an eARC connection.
[eARC mode] does not work when the text-to-speech function for on-screen text within
the TV’s accessibility features is enabled.
Connect the audio system to an HDMI cable with Ethernet.
Connect the audio system to the TV’s HDMI input terminal bearing the text “ARC” or
“eARC/ARC”.
Configure the settings as follows.
[Settings] — [Display & Sound] — [Audio output] — [eARC mode] — [Auto]
[Settings] — [Display & Sound] — [Audio output] — [Speakers] — [Audio system]
To Next Page
Loading...
Need help?
General
