Hint
To change the order or hide a displayed item, press the (Up) button on the
remote control with that item highlighted, and [Move] and [Hide] will be displayed. If
you select [Move], use (Left) / (Right) on the remote control to move the item
to the desired position, and then press the (Enter) button on the remote control.
You can switch to TV broadcasting by simply pressing the TV button on the remote
control.
[10] Getting Started
Performing acoustic auto calibration
You can correct the audio to the best acoustics for your watching environment by using
the remote control microphone to measure a test sound from the TV. (This setting may not
be available depending on the model.)
Models that support acoustic auto calibration have the following setting.
[Settings] — [Display & Sound] — [Sound] — [Acoustic auto calibration]
Note
Calibration effects will vary depending on your watching environment.
A loud test sound will be played from the TV during measurement.
Do not block the microphone opening at the end of the remote control during
measurement.
Do not move the remote control during measurement. Doing so may result in
incorrect measurement.
Perform the calibration when your surroundings are quiet. Noise may result in
incorrect measurement.
Acoustic auto calibration cannot be performed if you are using a sound bar. Change
the following setting.
[Settings] — [Display & Sound] — [Audio output] — [Speakers] — [TV speakers]
To Next Page
Loading...
Need help?
General
