EasyManua.ls Logo

Sony Camcorder - User Manual

Sony Camcorder
1 page
Print Icon
Loading...
Dimension & Cable Connection
* How to Install
* INSTALLATION
* Camera Adjustment
① Connect Video & Power Line
(12V DC Regulated Power)
② Please set the position where you
want to connect the camera.
③ Loosen the locking screws and
adjusting camera angle.
④ Combine each camera parts and lock
& tight the each locking screws.
* SETTINGS
Settings can be made using the 5 buttons
located on the side of the camera.
UPUPSET-UPSET-UP DOWNDOWN LEFTLEFT RIGHTRIGHT
CAMERA OPERATION ( )
OSD REMOTE CONTROL OSD
* DC / VIDEO
* MANUAL
* AWC
* LOW
* LOW
* LOW
* AUTO
* RESET
* MIRROR
* MOTION DETECTION
* COLOR
* AUTO
(Digital noise reduction)
SENS-UP (Low illuminance)
LENS (selection)
AGC (Auto Gain control)
(Backlight compensation)
(condition and speed control)
WHITE BALANCE control
DNR
SPECIAL
EXIT
SHUTTER
BACKLIGHT
* MANUAL
* ESC
* ATW
* OFF
* HIGH
* HIGH
* OFF
* OFF
* HIGH
* OFF
* CAMERA ID
* SYNC
* PRIVACY
* SHARPNESS
* RETURN
* MANUAL
* FLK
* MIDDLE
* MIDDLE
* MIDDLE
Hood Camera
Specification
WEATHERPROOF
High Digital Hood Color IR Day/Night CameraHigh Digital Hood Color IR Day/Night Camera
Built-in 20-power infrared LEDs with CDS sensor
Camera OSD Control by External Wired Remote Controller
MODEL
Image Pick-Up Device
TV System
Total Pixels
Effective Pixels
Scanning Frequency
Scanning System
Synchronization
Resolution
Minimum Illumination
S/N Ratio
White Balance
Gamma Characteristic
Video Output
Electronic Shutter Speed
OSD
BLC
AGC
DNR
Day&Night(Color)
Sharpness
Privacy
Power Supply
Power Consumption
Lens
Operational Temp.
Storage Temp.
Dimension
Weight
1/3" SONY SUPER HAD CCD1/3" SONY SUPER HAD CCD
NTSC,PAL
NTSC=811(H) * 508(V) / PAL=795(H) * 596(V)
NTSC=768(H) * 494(V) / PAL=752(H) * 582(V)
NTSC=15.734KHz(H) / 59.94Hz(V) / PAL=15.625KHz(H) / 50.00Hz(V)
2:1 Interlace
Internal
560TV Lines
CDS OFF : 0.1Lux / CDS ON : 0.00006Lux
More than 50dB
ATW/AWBC/MANUAL(1800K ~ 10,500K)
0.45
CVBS : 1.0Vp-p 75ohm
NTSC=Auto/Manual(1/60sec~1/120,000sec) / PAL=Auto/Manual(1/50sec~1/120,000sec)
Built-in
Low,Middle,High,Off Selectable
Low,Middle,High,Off Selectable
Low,Middle,High,Off Selectable
On/Auto Selectable (Electrical)
On/Off (Level Adjustable)
On/Off (4 Programmable Zone)
DC 12V (AC 24V Option)
CDS ON:350mA Max
DC Auto Iris Varifocal Lens(4mm-9mm)
-10 ~ +50 Deg C. RH 95% Max.
-20 ~ +60 Deg C. RH 95% Max.
100mm(W) * 125mm(H) * 216mm(D)
1500g
QSB520SR
Cable Connection
Power jack Video Jack
Power (+)
Power (-)
Video Signal
Video GND
DC
SHUTTER SPEED
WHITE BAL
BLC
AGC
DNR
SENS-UP
SPECIAL
EXIT
DC
ELC
ATW
HIGH
OFF
LOW
OFF
Built-in 35pcs IR LEDs, it can capture clear
images as far as 30~50m away even completely darkness.
Sunshield
Focus Control
Case
Cable
Base
SET-UP
LEFT
UP DOWN
RIGHT
1/3” SONY SUPER HAD
560TV Lines
DC Auto iris Varifocal
Lens(4mm-9mm)
IR Day/Night Capability
IP65
Registant
Weather
Function
Backlight
Compensation
BLC
LENS
DC/VIDEO
Shutter
High Speed
Resolution
Horizontal
560
Motion
Detection
OSD
Auto White
Balance
DAY & NIGHT
CCD
1/3"
0.00006Lux
Minimum
Illumination
Auto
Gain
Control
Sensitivity Up
2 x~128 x
OSD
Bracket
360˚
360
˚
180
˚
WW
Digital Day/Night Color Camera
100mm
74mm
216mm
155mm
120mm
58mm
125mm
82mm
FRONT
SIDE
WIDETELE --
FAR --
NEAR
OSD REMOTE CONTROL
SET-UP
LEFT
UP DOWN
RIGHT
0M 10M 20M
OUTDOOR
INDOOR
30M 40M 50M 60M 70M 80M 90M 100M
Digital Day/Night Color Camera
IR LED
CDS Sensor
DC Auto Iris Varifocal Lens
(4mm-9mm)
Question and Answer IconNeed help?

Do you have a question about the Sony Camcorder and is the answer not in the manual?

Overview

This document describes the QSB520SR High Digital Hood Color IR Day/Night Camera, a weatherproof surveillance device designed for both indoor and outdoor use.

Function Description

The QSB520SR is a high-performance digital color IR day/night camera equipped with a 1/3" SONY SUPER HAD CCD image pick-up device. It features built-in 20-power infrared LEDs and a CDS sensor, enabling it to capture clear images in various lighting conditions, including complete darkness, up to a distance of 30-50 meters. The camera offers Day/Night capability, automatically switching between color and monochrome modes based on ambient light. Its DC Auto Iris Varifocal Lens (4mm-9mm) allows for flexible adjustment of the field of view. The camera's On-Screen Display (OSD) can be controlled via an external wired remote, providing convenient access to various settings.

Important Technical Specifications

Model: QSB520SR

Image Pick-Up Device: 1/3" SONY SUPER HAD CCD

TV System: NTSC, PAL

Total Pixels:

  • NTSC: 811(H) * 508(V)
  • PAL: 795(H) * 596(V)

Effective Pixels:

  • NTSC: 768(H) * 494(V)
  • PAL: 752(H) * 582(V)

Scanning Frequency:

  • NTSC: 15.734KHz(H) / 59.94Hz(V)
  • PAL: 15.625KHz(H) / 50.00Hz(V)

Scanning System: 2:1 Interlace

Synchronization: Internal

Resolution: 560TV Lines

Minimum Illumination:

  • CDS OFF: 0.1Lux
  • CDS ON: 0.00006Lux

S/N Ratio: More than 50dB

White Balance: ATW/AWBC/MANUAL (1800°K ~ 10,500°K)

Gamma Characteristic: 0.45

Video Output: CVBS: 1.0Vp-p 75ohm

Electronic Shutter Speed:

  • NTSC: Auto/Manual (1/60sec ~ 1/120,000sec)
  • PAL: Auto/Manual (1/50sec ~ 1/120,000sec)

OSD: Built-in

BLC (Backlight Compensation): Low, Middle, High, Off Selectable

AGC (Auto Gain Control): Low, Middle, High, Off Selectable

DNR (Digital Noise Reduction): Low, Middle, High, Off Selectable

Day&Night(Color): On/Auto Selectable (Electrical)

Sharpness: On/Off (Level Adjustable)

Privacy: On/Off (4 Programmable Zone)

Power Supply: DC 12V (AC 24V Option)

Power Consumption: CDS ON: 350mA Max

Lens: DC Auto Iris Varifocal Lens (4mm-9mm)

Operational Temperature: -10 ~ +50 Deg C. RH 95% Max.

Storage Temperature: -20 ~ +60 Deg C. RH 95% Max.

Dimension: 100mm(W) * 125mm(H) * 216mm(D)

Weight: 1500g

Usage Features

The camera offers a comprehensive set of adjustable features through its OSD menu, accessible via a 5-button remote control.

Lens Selection: Users can choose between Manual or DC/Video control for the lens. Shutter Control: Options include ESC (Electronic Shutter Control), Manual, and FLK (Flickerless) to adapt to different lighting environments and prevent flickering. White Balance Control: Provides ATW (Auto Tracking White Balance), AWC (Auto White Balance Control), and Manual settings to ensure accurate color reproduction under varying light sources. Backlight Compensation (BLC): Offers Off, Low, Middle, and High settings to improve visibility in scenes with strong backlighting. Auto Gain Control (AGC): Allows adjustment of signal amplification with Off, Low, Middle, and High options to optimize image brightness in low-light conditions. Digital Noise Reduction (DNR): Features Off, Low, Middle, and High settings to reduce image noise, especially in low-light scenarios, resulting in clearer video. SENS-UP (Low Illuminance): Provides Off and Auto modes to enhance sensitivity in extremely low light, making objects visible even in near darkness.

Special Functions:

  • Camera ID: Assigns a unique identifier to the camera.
  • Color: Adjusts color settings.
  • Sync: Manages synchronization settings.
  • Motion Detection: Enables motion-triggered recording or alerts.
  • Privacy: Allows definition of up to 4 programmable zones to mask sensitive areas within the camera's view.
  • Mirror: Flips the image horizontally.
  • Sharpness: Adjusts the level of image detail.
  • Reset: Restores all settings to factory defaults.
  • Return: Navigates back through the OSD menu.
  • Auto: Automatically adjusts settings.

The camera is designed for easy installation, with clear instructions provided for connecting video and power lines (12V DC Regulated Power). Its weatherproof design (IP65 rating) ensures durability and reliable operation in outdoor environments. The camera's physical dimensions are 100mm(W) * 125mm(H) * 216mm(D), and it weighs 1500g.

Maintenance Features

The camera's design facilitates straightforward maintenance. The "How to Install" section also provides guidance on physical adjustments:

  1. Connecting Video & Power Line: Ensure proper connection of the 12V DC regulated power and video signal cables.
  2. Positioning: Set the camera to the desired position.
  3. Adjusting Camera Angle: Loosen the locking screws to adjust the camera angle as needed.
  4. Securing Components: Combine all camera parts and tighten the locking screws to ensure stability.

The OSD menu includes a "Reset" option, which can be used to revert all settings to their factory defaults, simplifying troubleshooting or re-configuration. The robust construction and weatherproof rating minimize the need for frequent maintenance related to environmental exposure.

Sony Camcorder Specifications

General IconGeneral
BrandSony
ModelCamcorder
CategoryCamcorder
LanguageEnglish

Related product manuals