47
Advanced operations
Before you start recording or during recording, press DATE or TIME. You can record
the date or time displayed in the viewfinder or on the LCD screen with the picture.
Press DATE (or TIME), then press TIME (or DATE) to display the date and time
together.
The clock is set to East Coast Standard time at the factory. You can reset the clock in the
menu system.
To stop recording with the date and/or time
Press DATE and/or TIME again. The date and/or time indicator disappears. The
recording continues.
To edit a title you have stored
In step 3, select CUSTOM1 or CUSTOM2, depending on which title you want to edit,
then change the title.
Note
You cannot enter over 20 characters title.
If you take 5 minutes or longer to enter characters while a cassette is in the
camcorder
The power goes off automatically. Characters you have entered remain. Turn
STANDBY down once and then up again, then proceed from step 1.
To delete a title
In step 4, turn the control dial to select [M] then press the dial. The last character is
erased. Repeat this step until all characters are deleted.
Making your own titles
Recording with the date/time
JUL 4 1999
5:30:00 PM
5:30:00 PM
JUL 4 1999
DATE TIME
DATE
TIME
To Next Page
Loading...
Need help?
General