37
Advanced Recording Operations
Using the fader function
(1) When fading in [a]
In the standby mode, press FADER until the desired fader indicator flashes.
When fading out [b]
In the recording mode, press FADER until the desired fader indicator flashes.
The indicator changes as follows:
no indicator T MONOTONE T BOUNCE
FADER t M.FADER t STRIPE
The last selected fader mode is indicated first of all.
(2) Press START/STOP. The fader indicator stops flashing.
After the fade in/out is carried out, your camcorder automatically returns to
the normal mode.
To cancel the fader function
Before pressing START/STOP, press FADER until the indicator disappears.
The date, time indicator and title do not fade in or fade out
Erase them before operating the fader function if they are not needed.
While using the bounce function, you cannot use the following functions:
– Focus
– Zoom
– Picture effect
Note on the bounce function
The BOUNCE indicator does not appear in the following mode or functions:
– D ZOOM is set to the mode other than OFF in the menu settings.
– Wide mode
– Picture effect
– PROGRAM AE
1
FADER
FADER
To Next Page
Loading...
