Sony CDP-101 - Handling Precautions; Electrostatic Discharge (ESD) Prevention; Optical System Block Handling

CDP-101
— CAUTION FOR ELECTROSTATIC BREAKDOWN —
NOTES ON HANDLING THE OPTICAL SYSTEM BLOCK (KSS-100A)
SeGES eh 2 a ae pe
The laser diode in the optical pick-up block may 1. Place a conductive sheet on the workbench.
suffer electrostatic breakdown because of the poten- (The black sheet used as repair parts wrapping.)
tial difference generated by the charged electrostatic 2. Place the set on the conductive sheet so that the
load, etc. uP clothing and the human body. ; chassis touches the sheet. (This makes it the same
The printed matter below is included in the repair potential as the conductive sheet.)
parts. During repair, use the procedure in the printed . ;
anther 3. Place your hands on the conductive sheet, (This
The following method is an example for reference makes them the same potential as the sheet.)
purposes: 4. Remove the optical system block from the bag
‘| (conductive).
|
5. Perform work on top of the conductive sheet,
Be careful that clothing does not touch the optical
pick-up block.
Printed Matter Included in the Repair Parts
When
opening
or
repairing
a
KSS-100A,
the
procedure
for
grounding
as
follows
is
required
to
prevent
damage
caused
by
static electricity.
1 Grounding for the human body
Be sure to put on a wrist-strap for grounding (with impedance lower than 10® 92) whose other end-is
grounded, The strap works to drain away the static electricity build-up on the human body,
Grounding for the work table
Be sure to lay on the table a conductive sheet (with impedance lower than 10° 2) such as a sheet of
copper, which is grounded,
As static electricity build-up on clothes is not drainded away, be careful not to let your clothes touch
the KSS-100A.
@) wrist-strap for grounding:
Protection cap
;
§
}
i
}
3
a4
i
of
|
H
4
|
4
KSS-100A
@) conductive sheet