Sony CDP-101 - Hardware Nomenclature; Screw Identification and Types; Fastener Types (Nuts, Washers, Retaining Rings)

,
:
:
3
é
i
3
i
}
¥
1
i
\
t
:
i
1
Screw: —P3x10
L: Length inmm
D: Diameter inmm Seer mr}
Type of head
indicated slotted-head only.
Unless otherwise indicated, it means
cross-recessed head (Phillips type).
ii
rt
—
Reference
Designation
HARDWARE NOMENCLATURE
Nut, Washer, Retaining ring:
N3
L_____piameter of usable screw or shaft
Reference designation 3
Description
Remarks
" SELF-TAPPING SCREWS
self-tapping screw
ex: TA,P3x 10
Reference
pan-head self-tapping
screw
| binding-head seif-
tapping (TA, B) screw for
replacement
Description Remarks
Designation
SCREWS
pan-head self-tapping
screw with washer face
binding-head self
tapping (TA, B) screw and
flat washer for replacement
binding-head (B) screw for
replacement
binding-head (B) screw and
pan-head screw
pan-head thread-rolling
screw with washer face
binding-head (B) screw and
flat washer for replacement
pan-head screw with
washer face flat washer for replacement
SET SCREWS
5
binding-head (B) screw and
spring washer for replace-
pan-head screw with
set screw
spring washer
ment
binding-head (B) screw and
pan-head screw with
hexagon-socket set screw
ex: SC 2.6 x 4, hexagon
socket
spring and flat washers spring and flat washers for
NUT
replacement
binding-head (B) screw for
round-head screw
replacement
WASHERS
flat-countersunk-head
screw
oval-countersunk-head
screw o
binding-head screw
binding-head (8) screw for
replacement
truss-head screw
flat-fillister-head screw
fillister-head screw
brazier-head screw
flat washer
internal-tooth lock
washer
Sony Corporation
Consumer Products Group
9-951-028-11
—104—
Technical Support Dept.
ex: LW3, internal
English
82L05147-1
Printed in Japan
© 1982