Sony CDP-C215 - Adding Selections and Linking

You can designate a time and the unit will make 2
different programs of setections each fitting within that
period. Use this function, by designating the length of your
tape, for editing both sides of a tape.
To add selection(s) — LINK —
After all selections on the disc have been programmed, if
there is selection(s) within the remaining time, “LINK” and
the selection numbers will blink.
oe,
1) 2 3 4 steers 63 8
- oF ~
= we 77S
moe 1 148 Cm)
To add selection, press the EDIT/TIME FADE again. A
program will be made automatically to fit the playing time
as close as possible to the remaining time.
If the remaining time can contain other selection(s),
“LINK” and the selection number keep blinking. When
“LINK” blinks, if the disc is changed by another disc, the
new selection number(s) on the new disc that fit in the
remaining time will blink.
“EDIT” disappears when the playing time becomes equal
to the designated time. Whether “LINK” is blinking or not,
you can change the disc by another disc and choose
selection(s) to fit the remaining time.
To disappear “EDIT” in the window, press IB button.
To play the program
Press >.
The selections for side A will be played and then the unit
will pause. ‘“B” lights up in the tape side indicator. Set the
tape to the beginning of side B, then press or U1
The selections for side B will be played.
Note
Playback can be performed when “EDIT” is displayed.
To stop playing
Press Mi.
You can play the same program repeatedly as long as you
do not cancel time edit or erase the program.
To cancel time edit
Press CONTINUE and return to the continuous playing
mode.
The program will be erased.
To erase the entire program
Press IB once during stop; twice during play.
The program is also erased, when you turn off the unit.
To include desired selections in the program
1 Make your own program of the desired selections.
See page 12 for instructions.
2 Follow the procedure as shown on the preceding page.
Just designate the length of your tape; you need not
subtract the length of your program. The unit will place
your selections at the beginning of its program and add
other selections to fit the remaining time.
To check the program
See page 13.
To designate a different time for each side
Execute steps 1 to 4 and press 88. Then repeat steps 2 and 4.
Do not execute step 5.
if your disc has more than 20 selections
Selections over 20 cannot be programmed with the time edit
function; program desired selections before using the time edit
function. See page 12 for details.
15