EasyManua.ls Logo

Sony CDP-C715 User Manual

Sony CDP-C715
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Sony CDP-C715 and is the answer not in the manual?

Sony CDP-C715 Specifications

General IconGeneral
Channels2
Frequency Response2 Hz - 20 kHz
Output Level2.0 V
Channel separation100 dB
Digital OutputsCoaxial
TypeCD Player
Disc formatCD
Digital converter1-bit D/A converter
Dimensions430 x 300 x 90 mm

Summary

Installing the CD Player

Notes on Installation

Advice on placing the unit for proper air circulation and avoiding heat sources.

On moisture condensation

Instructions for handling condensation inside the player.

Maintenance

Cleaning the cabinet

How to clean the unit's exterior with a soft cloth and mild detergent.

Cleaning discs

Guidance on cleaning discs before playing.

Precautions

On Safety

Essential safety guidelines for operating the CD player, including electrical precautions.

On operation

Recommendations for efficient operation and extending the unit's lifespan.

Connections

For Correct Connections

General guidelines for making proper and secure connections to an amplifier.

To Connect to an Amplifier

Diagram and instructions for connecting the CD player to an amplifier.

Location of Controls

Front panel

Identification and explanation of controls on the main unit's front panel.

Remote Commander

Preparing the Remote Commander

Steps for setting up the remote control, including battery installation and operational notes.

Playing a Disc – Continuous Play

To stop play

Instructions on how to pause or stop playback of a disc.

Caution on adjusting volume

Warning about potential speaker damage from sudden volume changes.

To listen with the headphones

How to connect and control volume for headphone listening.

Notes on handling discs

Guidelines for proper handling and care of compact discs.

Information Display

During stop

Explanation of information displayed on the unit when it is stopped.

If you press TIME/MEMO during play...

Details on how the display changes when TIME/MEMO is pressed during playback.

Locating a Particular Selection

Locating a selection in sequence (Automatic Music Sensor)

How to find the beginning of a track using the Automatic Music Sensor.

To locate directly

Instructions for directly selecting a track number using buttons.

Selecting a Desired Disc

Locating a Particular Point in a Selection

To search quickly while monitoring the sound

How to fast forward or rewind while listening to locate a point.

To search quickly by observing the display

How to locate a point by monitoring the display without sound.

Playing in a Random Order – Shuffle Play

To stop play

How to stop the shuffle play mode.

To cancel shuffle play

Procedure to exit shuffle play and return to continuous mode.

To select a desired disc during '1 DISC' shuffle play

How to choose specific discs for shuffle play.

To Play Only the Desired Discs in a Random Order - Select Shuffle Play

Instructions for selecting specific discs for random playback.

Playing in a Desired Order – Program Play

Designating the Playing Time - Program Edit

Steps to create a program by selecting tracks and setting durations.

Checking the Programmed Selections

Clearing the Programmed Selections

Methods to clear programmed tracks from memory, including whole program, last, or specific selections.

To check the step of programmed selections

How to view the number of programmed tracks.

To check the remaining time of the selection being played

How to check the remaining time of the current or total program.

Designating the Total Playing Time - Time Edit

To set time fade

Instructions to set fade duration for editing tapes.

To set the seconds

How to adjust seconds for tape length designation.

Time Edit and Program Operations

Editing and Playing Programs

Instructions for adding, playing, stopping, and checking programmed selections.

Managing Time Edit Functions

Procedures for canceling time edit, erasing programs, and designating time for both sides.

Convenient Features for Tape Recording

Fading in/Fading out

How to apply fade in and fade out effects to audio.

Fading out after a desired duration - Time Fade

Instructions for setting an automatic fade out at a specific time.

Locating the loudest portion of the disc - Peak Search

To activate the peak search

How to start the peak search function to find the loudest part of a disc.

To start play immediately

How to begin playback directly after activating peak search.

To stop the peak search

Procedure to halt the peak search process.

Playing Repeatedly - Repeat Play

To cancel repeat play

How to disable the repeat play function.

Playing the Beginning of Each Selection - Music Scan

To stop music scan play

How to halt the music scan playback.

Starting play at the selection being played during music scan

How to resume normal play from a scanned selection.

To change the playing time

How to adjust the duration of the music scan preview.

Enhanced Surround Effects - Digital Signal Processor

Choose the desired DSP mode

Instructions for selecting different sound effect modes.

Adjust to the desired equalizer and reverb level*.

How to fine-tune equalizer and reverb settings for sound effects.

To cancel the DSP mode

Procedure to turn off the digital signal processor effects.

Memorizing a DSP Mode

To make a DSP file

Steps to save custom DSP settings as a file.

To change DSP files

How to select or store different custom DSP files.

To change DSP mode without erasing the DSP file

How to adjust DSP settings manually without affecting stored files.

Clearing a DSP file

Procedure to delete a memorized DSP file.

On Custom Files

The four custom files you can store in memory

Overview of custom file types: Disc memo, Bank, Level file, and DSP file.

Memory backup for the custom files

Information on how custom file data is retained.

To clear custom files of all discs at once

Procedure to erase all stored custom files.

To check the items of the custom files

How to view and manage stored custom file information.

Keeping the Program in Memory – Bank

Memorizing a Bank

Steps to store a programmed sequence into memory as a bank.

Playing the Disc Using the Bank

How to play discs using the memorized bank programs.

Clearing the Bank

Procedure to delete a memorized bank.

Assigning Names to a Disc – Disc Memo

Using the MEMO INPUT button with the letter buttons on the remote commander

How to input disc names using the remote commander's buttons.

Move the cursor to select the next letter.

Steps to navigate and input characters for disc memos.

To change to numbers, return to the step A-1.

How to switch between letters and numbers for disc memo input.

Disc Memo Functions

Character Input and Rewriting

Details on usable characters and how to rewrite disc memo names.

Assigning and Managing Disc Memos

Methods for assigning, displaying, and clearing disc memos.

Preset the desired Output Level to a Disc - Level File

To preset a new level on to the current level file

How to set a new output level for a disc.

Clearing the Level File

Procedure to remove a memorized level file for a disc.

Timer Activated Playing

Activating the Power with an Audio Timer

Instructions for setting up timer-activated disc playback.

Specifications

Compact Disc Player

Technical specifications for the CD player, including frequency response and dimensions.

Remote Commander RM-D715

Technical specifications for the remote control unit.

Supplied Accessories

List of items included with the CD player package.

Optional Accessory

Information on available optional accessories.

Troubleshooting Guide

Common Problems and Solutions

Guidance on diagnosing and resolving common issues with the CD player.

Related product manuals