Sony CDP-CX270 - Page 5

When connecting to an amplifier without a video input
jack : Lae ;
CD player
To an AC outlet
To LINE OUT
To video input
© 6 OG
Z
To audio input
To an AC outlet
Amplifier
To an AC outlet
cot: Signal flow
What cords will | need?
Audio cord (1) (supplied)
Video cord (1) (supplied)
Yellow 4. T>——————T 1 veliow
Hookups
When connecting the cords, be sure to match the color-
coded plugs to the appropriate jacks on the
components: Yellow (video) to Yellow, Red (right) to
Red and White (left) to White. Be sure to make
connections firmly to avoid hum and noise.
Getting Started
When connecting to an amplifier with a video input jack
CD player Amplifier
VIDEO
VIDEO IN
)
AUDIO IN
When connecting to an amplifier without a video input
jack
CD player WV
© If you have a Sony receiver (amplifier) equipped with
the CONTROL A1 jack
Be sure to connect the player to the VIDEO 2 jacks on the
receiver (amplifier). When making this connection, leave
the COMMAND MODE of the player to CD2 which is set at
the factory.
If you further connect the player and the receiver
(amplifier) via the CONTROL A] jacks with the CONTROL
Al cord (not supplied), you can use the Automatic Function
Selection feature between these components. For details,
refer to the supplementary “CONTROL-A1 Control
System” instructions and the instructions supplied with the
receiver (amplifier). :
If you have a Sony receiver (amplifier) with the
On-Screen Display Control function
You can control the player using the on-screen display and
the remote supplied with the receiver.
For details, see page 22.