Sony CDP-CX270 - Page 7

What cords will | need?
¢ Audio cord (1) (supplied with the player to be connected)
¢ CONTROL AI cord (1) (not supplied)
1. Connect the players with the audio cord (see also
“Hookups” on page 5).
CDP-CX200 etc.
CDP-CX270/CX90ES
For details on this connection, refer to the
supplementary “CONTROL-A1 Control System”
instructions.
3 Set the COMMAND MODE sele¢tor of each
player.
Leave the COMMAND MODE of this player set to
CD2, and set that of the second player to CD3
COMMAND MODE)
co
123
[ou
Getting Started
4 When you turn on both players and this player”
detects the second player, “REMOTE” appears in
the second player's display.
You cannot operate the second player using the
controls on the second player while “REMOTE”
appears in the second player's display.
REMOTE
‘cO3
While the second player is selected, “2nd PLAYER”
appears in this player’s front panel display.
Note
Do not connect a player other than a Sony CD player
equipped with the CONTROL A] jacks to the LINE IN jacks
of this player. If you do, a loud noise may occur and damage
the speakers.
xe) You can connect the CD player CDP-CX153 as the
second player
Connect the CONTROL A11 jack of this player and the
CONTROL A jack of the CDP-CX153. For details, refer to
the supplementary “CONTROL-A1 Control System”
instructions.
Note that you cannot use the X-Fade Play function (see
page 21) when connecting the CDP-CX153.