Sony CDP-CX455 - DOOR SW Board

12
CDP-CX455
5 two screws
(BVTP 2.6
× 8)
3 screw (PTPWH 2.6 × 8)
1 screw (PTPWH 2.6 × 8)
1 Move the slider (pop-up) and the lever (pu joint) fully
in the direction of the arrow
A .
2 Install the gear (cam) in the direction shown
in the illustration and rotate it fully
in the direction of the arrow
B .
3 When the gear (cam) happens to go too deep,
return it to the original position
in the direction of the arrow
C .
4 gear (B)
2 gear (cam)
6 DOOR SW board
C
B
A
lever (pu joint)
two rotary switches
slider (pop-up)
gear (cam)
DOOR SW board
The levers of the two rotary switches on the D. SW board
are shown in the illustration below.
Precaution during the gear (cam) installation
3-8. DOOR SW Board