Sony CDP-M19 - Page 12

Playing
in
a
Desired
Order
-
Program
Play
You
can
make
a
program
by
designating
up
to
20
selections
in
the
order
you
want
them
to
be
played.
The
unit
will
play
the
disc
according
to
your
program.
PROGRAM
3 Choose selection and check the time
Total playing time (blinks)
-——- AMS——
6
If satisfactory go to the next step.
If not, repeat step 3 and choose another selection.
Programmed selection
5 Store selection.
PROGRAM
TRACK
MIN
SEC
2
ta err 3.24
: 6 Repeat steps 3 to 5.
IZ
To play the program
Press Ef (or B on the remote commander).
To stop playing
Press Hf.
You can play the same program repeatedly as long as you
do not cancel program play or erase the program.
To cancel program play
Press PROGRAM to enter the unit into the normal playing
mode. The program will be erased.
To check you program
Press fl on the remote commander (or press 8) to enter
the unit into the pause mode, and then press Pl to check
each programmed selection.
To erase your program
Each time you press @, the last selection will be erased.
Press to erase the entire program.
If “----” is displayed instead of the actual time
~ you have programmed a selection number over 20.
— the total time has exceeded 100 minutes.
Note:
You cannot make a program during play.
If you press REPEAT during program play
The program will be repeated after all the programmed selections
are played once.
(Repeating one selection only is not possible during program play.)