CDX-G1200U/G1201U/G1202U/G1280UM
6
NOTE OF REPLACING THE IC001 AND IC1301 ON
THE MAIN BOARD
IC001 and IC1301 on the MAIN board cannot replace with single.
When these parts are damaged, replace the complete mounted
board.
NOTE OF REPLACING THE KEY BOARD
When the KEY board is defective, replace the FRONT PANEL
OVERALL ASSY (Ref. No. FP1).
TEST DISCS
Use following TEST DISC (for CD) when this unit confi rms the
operation and checks it.
Part No. Description
3-702-101-01 DISC (YEDS-18), TEST
4-225-203-01 DISC (PATD-012), TEST
NOTE OF PERFORMING THE OPERATION CHECK
When performing the operation check in the state that is removed
the CD mechanism deck from the main unit, it is necessary to use
a long fl exible fl at cable.
When performing the operation check, use following fl exible fl at
cable.
Part No. Description
1-846-819-31 CABLE FLEXIBLE FLAT (27 CORE)
(Length: 150 mm)
CANCELING THE DEMO MODE
You can cancel the demonstration display
which appears when the source is off and
the clock is displayed.
1 Press MENU, rotate the control dial to
select [GENERAL], then press it.
2 Rotate the control dial to select [SET
DEMO], then press it.
3 Rotate the control dial to select [SET
DEMO-OFF], then press it.
The setting is complete.
4 Press (back) twice.
The display returns to normal reception/
play mode.
CLEANING THE CONNECTORS
The unit may not function properly if the
connectors between the unit and the front
panel are not clean. In order to prevent this,
detach the front panel (page 7) and clean
the connectors with a cotton swab. Do not
apply too much force. Otherwise, the
connectors may be damaged.
Notes
• For safety, turn off the ignition before cleaning the
connectors, and remove the key from the ignition
switch.
• Never touch the connectors directly with your
fingers or with any metal device.
and clean
To Next Page
Loading...
