•
16
Your
dealer
may
not
handle
some
of
the
above
listed
accessories.
Please
ask
the
dealer
for
detailed
information.
MPEG
Layer-3
audio
coding
technology
and
patents
licensed
from
Fraunhofer
lIS
and
Thomson.
Design
and
specifications are subject
to
change
without notice.
• Halogenated flame retardants are not used
in
the
certain printed wiring boards.
• Halogenated flame retardants are not used
in
cabinets.
• Packaging cushions are made from paper.
The
following
checklist
will
help
you
remedy
problems
you
may
encounter
with
your
unit.
Before
going
through
the
checklist
below,
check
the
connection
and
operating
procedures.
General
No power
is
being supplied to the unit.
•
Check
the connection.
If
everything is in order, check
the fuse.
•
If
the unit is turned
off
and the display disappears, it
cannot
be operated with the remote commander.
---+
Turn
on
the unit.
The power antenna (aerial) does not extend.
The
power antenna (aerial) does not have a relay box.
No sound.
•
The
volume is too low.
•
The
ATT function is activated.
• The position
of
the fader control "FAD" is not set for
a 2-speaker system.
• The
CD
changer is incompatible with the disc format
(MP3/wMA/AAC).
---+
Play back with a Sony MP3 compatible
CD
changer,
or
this unit.
No beep sound.
•
The
beep sound is canceled (page 10).
• An optional power amplifier is connected and you are
not using the built-in amplifier.
The contents of the memory have been erased.
•
The
RESET
button has been pressed.
---+
Store again into the memory.
•
The
power supply lead
or
battery has been
disconnected.
•
The
power supply lead is not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is
switched.
The
leads are not matched correctly with the
car's
accessory power connector.
During playback or reception, demonstration
mode starts.
If
no operation is performed for 5 minutes with
"DEMO-ON"
set, demonstration mode starts.
---+
Set
"DEMO-OFF"
(page 10).
The display disappears from/does not appear
in
the display window.
•
The
dimmer
is set
"DIMMER-ON"
(page 10).
•
The
display disappears
if
you press and hold (
OFF).
---+
Press and hold
(OFF)
on the unit until the
display appears.
•
The
connectors are dirty (page 14).
The Auto Off function does not operate.
The
unit is turned on.
The
Auto
Off
function activates
after turning
off
the unit.
---+
Turn
off
the unit.
Card remote commander operation
is
not
possible.
Make sure the insulation film has been removed
(page 4).
DSO does not function.
Depending on the type
of
car
interior
or
type
of
music,
DSO
may
not have a desirable effect.
CD/MD playback
The disc cannot be loaded.
• Another disc is already loaded.
•
The
disc has been forcibly inserted upside down
or
in
the wrong way.
The disc does not playback.
• Defective
or
dirty disc.
• The CD-Rs/CD-RWs are not for audio use (page 13).
MP3IWMAlAAC files cannot be played back.
The disc is incompatible with the
MP3/WMAI
AAC
format and version (page 13).
MP3IWMAlAAC files take longer to play back
than others.
The
following discs take a longer time to start
playback.
- a disc recorded with a complicated tree structure.
- a disc recorded in Multi Session.
- a disc to which data can be added.
The display items do not scroll.
• For discs with very many characters, those may not
scroll.
• "A.SCRL" is set to
"OFF".
---+Set
"A.SCRL-ON"
(page 10).
---+
Press and hold (
DSPL)
(SCRL).
The sound skips.
• Installation is not correct.
---+
Install the unit at an angle
of
less than 45
0
in a
sturdy part
of
the car.
• Defective
or
dirty disc.
To Next Page
