Adjusting the sound
characteristics
1 Press the select button repeatedly
until the desired item appears.
2 Rotate the volume control dial to
adjust the selected item.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
The
following items can be set (follow the page
reference for details):
"e"
indicates the default settings.
EQ3
To select an equalizer type:
"XPLOD"
(e),
"VOCAL," "EDGE," "CRUISE," "SPACE,"
"GRAVITY,"
"CUSTOM"
or
"OFF."
DSO
To select the
DSO
mode:
"1,"
"2"
(e),
"3"
or
"OFF." The larger the number, the more
enhanced the effect.
When
tuner is selected as the source, the default
setting is "OFF."
LOW*1, MID*1,
HI*1
(page
9)
To customize the equalizer curve.
BAL (Balance)
To adjust the balance between the right and left
speakers: "RIGHT-IO" -
"CENTER"
(e)-
"LEFT-lO"
FAD (Fader)
To adjust the balance between the front and rear
speakers: "FRONT-IO" -
"CENTER"
(e)-
"REAR-lO"
SUB (Subwoofer volume)
To adjust the subwoofer volume:
"+10 dB" -
"0
dB"
(e)
--
"-10
dB"
("ATT" is displayed at the lowest setting.)
AUX*2
(A.UX
level)
To adjust the volume level for each connected
auxiliary equipment. This setting negates the
need to adjust the volume level between sources
(page 10).
Adjustable level: "+18
dB"
-
"0
dB"
(e)-
"-8
dB"
*1 When EQ3 is activated.
*2 When
AUX
source is activated.
Customizing the equalizer curve
-EQ3
"CUSTOM"
of
EQ3 allows you to make your
own equalizer settings.
1 Select a source, then press the select
button repeatedly to select "EQ3."
2 Rotate the volume control dial to
select "CUSTOM."
3 Press the select button repeatedly
until "LOW," "MID" or "HI" appears.
4 Rotate the volume control dial to
adjust the selected item.
The
volume level is adjustable in I dB steps,
from
-10
dB to
+10
dB.
ana,
LUll"
-1-
bel]
Repeat steps 3 and 4 to adjust the equalizer
curve.
To
restore the factory-set equalizer curve,
press and hold the select button before the
setting is complete.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Tip
Other
equalizer types are also adjustable.
1 Press and hold the select button.
The setup display appears.
2 Press the select button repeatedIy
until the desired item appears.
3 Rotate the volume control dial to
select the setting (example "ON" or
"OFF").
4 Press and hold the select button.
The
setup is complete and the display returns
to normal play/reception mode.
Note
Displayed items will differ, depending on the source
and
setting.
The
following items can be set (follow the page
reference for details):
"e"
indicates the default settings.
continue to next page
-+
•
9
To Next Page
Loading...
