Sony D-E200 - Printed Wiring Boards; Main Board (Side A) Layout

– 15 – – 16 –
D-E200/E201/E206CK/E251
5-4. PRINTED WIRING BOARDS — MAIN SECTION —
1
A
B
C
D
E
F
G
H
I
J
234567891011
MAIN BOARD (SIDE A)
RED
BLK
VIO
BLK
BLK
VIO
BLK
RED
M501
SLED MOTOR
M502
SPINDLE MOTOR
OPTICAL
PICK-UP
BLOCK
DAX-11A
D-E251
D-E200/E201/E206CK
S802
MEGA BASS
OFF ON
S803
HOLD
(OFF) (ON)
04
(12)
12
1-677-378-
VDR101
VDR201
VDR301
R411
C431
Note on Printed Wiring Boards:
• Y : parts extracted from the conductor side.
•
a
: Through hole.
• b : Pattern from the side which enables seeing.
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B) pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A) parts face are indicated.
Common Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1
/
4
W or less unless otherwise
specified.
• % : indicates tolerance.
• C : panel designation.
• U : B+ Line.
• Power voltage is dc 4.5 V and fed with regulated dc power
supply from external power voltage jack.
• Voltages and waveforms are dc with respect to ground in
playback mode.
no mark : CD PLAY
∗
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J : CD