Sony D-E666 - 5 Diagrams; Explanation of IC Terminals

9
D-E666/EJ620/EJ621/EJ622/EJ623/EJ625/EJ626CK
Pin No. Pin name I/O Description
1 VSS — Ground terminal.
2 IRRMCO — Not used (OPEN).
3 FOKI I Focus OK signal input from the digital servo processor (IC601). “L”: NG, “H”: OK
4 AGCPWM O AGC control pulse signal output terminal.
5 RESERVE — Not used (OPEN).
6 RESERVE — Not used (OPEN).
7 AMUTE O Analog audio muting ON/OFF control signal output terminal. “H”: muting ON
8 VCC2 ON O VCC2 voltage control signal output terminal.
9 XRST O Reset signal output to IC601. “L”: reset
10 SCK O Serial data transfer clock signal output to IC601.
11 MSDTI I Serial data input from the IC601.
12 MSDTO O Serial data output to IC601.
13 WAKE UP O WAKE-UP control signal output terminal (for system standby reset).
14 SEL I Plug-in detection signal input terminal of LINE OUT/OPTICAL OUT.
15 CHGMNT I Battery charge voltage detection input from the power control (IC401).
16 KEY2 I Volume key input terminal.
17 BATMNT I Battery voltage detection signal input terminal
18 KEY1 I Key input terminal.
19 RMKEY I Key input from the headphone with remote commander (A/D input).
20 DCINMNT I
DC input voltage detection input terminal (A/D input) and DC input jack use/no use
detection input terminal.
21 OPEN I
CD door open/close detection switch (S801) input terminal.
The stop status is reset with the falling edge of input signal.
22 VREFL I Reference voltage input terminal (0V) for A/D converter.
23 VREFH I Reference voltage input terminal (+2V) for A/D converter.
24 VDD — Power supply terminal (+2V).
25 SCOR I Sub-code sync (S0+S1) detection signal input from the IC601.
26 GRSCOR I GRSCOR signal input from the IC601.
27 MIR I FG pulse signal input.
28 BEEP O Beep sound output to the headphone amplifier (IC302).
29 RESERVE — Not used ( Fixed at “H”).
30 RESERVE — Not used ( Fixed at “H”).
31 RESERVE I Not used ( Fixed at “H”).
32 TSB O Communication data bus output of headphone with remote commander.
33 TXTSKIP — Not used (OPEN).
34 XDIG VOL — Not used (OPEN).
35 CD RW — Not used (OPEN).
36 COMPRESSION I G PROTECTION switch input.
37 DIG TU — Not used (Fixed at “H”).
38 AVLS I
AVLS (Automatic Volume Limiter System) switch (S803) input terminal.
“L”: normal mode, “H”: limit mode
39 HOLD I HOLD switch (S803) input terminal. “L”: hold ON, “H”: hold OFF
40 EXBAT I External battery detection signal input terminal.
SECTION 5
DIAGRAMS
5-1. EXPLANATION OF IC TERMINALS
IC801 (SYSTEM CONTROLLER) T5U87-05 (E666/EJ625: E13, HK, KR, CH, AUS),
TMP88CM22F-MIRX-1 (EJ620/EJ621/EJ622/EJ623/EJ625: US, CND, AEP, UK, G, FR, EE/EJ626CK)