Using the wide mode
To return to the FN screen
Select 3 RETURN, 3, then press the center 0 on the control button. The PAGE1
screen appears. Next, select EXIT, then press the center 0 on the control button.
In wide mode, you cannot select the following functions:
-Old movie
-Bounce (I
During recording
You cannot select or cancel the wide mode. When you cancel the wide mode, set your
camcorder to the standby mode and then set 16:9WIDE to OFF in the menu settings.
Connection for a TV
Pictures recorded in 16:9WIDE mode automatically appear on the TV screen at full size
when:
-You connect your camcorder to a TV that is compatible with the video ID (ID-l/ID-2)
system.
-You connect your camcorder to the S video jack on the TV.
ID-I system
The ID-1 system sends aspect ratio information (16:9,4:3, or letter box) with video
signals. If you connect a TV compatible with the ID-1 system, the screen size is
automatically selected.
ID-2 system
The ID-2 system sends a copyright protection signal with ID-1 signals inserted between
video signals when you connect your camcorder to other equipment using the A/V
connecting cable.
:
50
To Next Page
