74
For details on the operation
t
page 61
Setup 4
4
The default settings are marked with .
Enables you to perform calibration when the touch panel buttons do not react at the
appropriate points where you touch.
Using the stylus, touch the × mark displayed on the screen.
To stop the calibration process mid-way, touch [Cancel]. The adjustments made up to that
point are not effected.
The × mark moves on the screen.
If you fail to press the right spot, the calibration is not performed. Press the × mark again.
Changes the function of some buttons to operate the camera installed in the Marine Pack.
The buttons will work as follows when the setting is [On].
– (Screen display on/off) button: Flash button for shooting. It does not work for viewing.
– / (zoom) button: Zoom button for shooting, Previous/next image button for viewing
• Macro recording is activated automatically when the setting is [On].
• For details, see the operating instructions supplied with the Marine Pack.
Calibration
Housing
On ( )
Changes the function of the buttons.
Off
Does not change any functions.
Calibration
Touch the "X"
Cancel
1/3
To Next Page
Loading...
