[314] Troubleshooting Troubleshooting Shooting still images/movies
The image is blurred.
Make sure that [SteadyShot] is set to [On].
The picture was taken in a dark location without the flash, resulting in camera-
shake. The use of a tripod or the flash is recommended. [Hand-held Twilight]
and [Anti Motion Blur] in [Scene Selection] are also effective in reducing blur.
[315] Troubleshooting Troubleshooting Shooting still images/movies
The monitor darkens after a short period of time passed.
If you do not operate the product for a certain period of time, the product will
automatically turn off. The product turns on again when you press the power
button.
[316] Troubleshooting Troubleshooting Shooting still images/movies
The flash takes too long to recharge.
The flash has been fired in succession in a short period. When the flash has
been fired in succession, the recharging process may take longer than usual to
avoid overheating of the camera.
[317] Troubleshooting Troubleshooting Shooting still images/movies
The control wheel does not work.
[Wheel Lock] is on. Hold down the Fn button until the lock is released, or set the
[Wheel Lock] to [Unlock].
To Next Page
Loading...
