Sony DSX-A510BD - Page 11

11GB
Before operation, set [SEEK BY] to [A-Z] for
searching by station name (page 21).
1 Press MODE to select [DB1], [DB2] or
[DB3].
2 Press / (SEEK –/+) to switch to
the previous/next station.
You can display a list of stations for easy searching.
1 During DAB reception, press (browse).
The unit enters Quick-BrowZer mode, and the
list of stations appears.
2 Rotate the control dial to select the
desired station, then press it.
Reception starts.
To exit the Quick-BrowZer mode
Press (back).
1 Press MODE to select [DB1], [DB2] or
[DB3].
2 Press MENU, rotate the control dial to
select [GENERAL], then press it.
3 Rotate the control dial to select [SET
AUTOTUNE], then press it.
The unit updates the list of stations.
1 While receiving the station that you want
to store, press and hold a number button
(1 to 6) until [MEM] appears.
1 After selecting the desired band, press a
number button (1 to 6).
If you enable DAB announcements, DAB
announcements can interrupt the currently
selected source.
1 Press MENU, rotate the control dial to
select [GENERAL], then press it.
2 Rotate the control dial to select [SET
ANNOUNCE], then press it.
3 Rotate the control dial to select [SET
ANNC-ON] or [SET ANNC-OFF], then press
it.
Note
During a DAB announcement, the volume is adjusted to
the level set for TA in RDS (page 12).
To listen to the same or similar program
even during weak reception
Set [SET SOFTLINK] to [ON] (page 21).
[FM-LINK] lights up when the corresponding FM
program is being received.
“Hard Link” follows the same program, and “Soft
Link” follows a similar program.
Searching for station by station name
Searching for a station by name
(Quick-BrowZer™)
Updating the station list (Auto tune)
Storing a station manually
Receiving stored stations
Setting DAB announcements
SOFT
LINK
DAB FM
Hard
Link
Soft
Link
Hard
Link
Soft
Link
OFF 
ON 