Do you have a question about the Sony DTC-ZA5ES and is the answer not in the manual?
Tape Speed | 8.15 mm/s |
---|---|
Sampling Frequency | 48 kHz, 44.1 kHz, 32 kHz |
Digital Inputs | 1 x Coaxial, 1 x Optical |
Digital Outputs | 1 x Coaxial, 1 x Optical |
Type | DAT Recorder |
Recording Time | Up to 120 minutes (with 120-minute tape) |
Analog Inputs | 1 x RCA (line) |
Dimensions (W x H x D) | 430 x 108 x 300 mm |
Frequency Response | 2 Hz - 22 kHz (48 kHz sampling) |
Details tape, recording head, time, speed, drum rotation, track pitch, sampling frequency, D/A conversion, frequency response, S/N, dynamic range, THD, and wow/flutter.
Details specifications for analog and digital input/output connectors, including impedance and levels.
Specifies power requirements for US, Canadian, and E models.
Procedures for testing AC leakage and warnings about safety-critical components.
Identifies and describes the function of front and rear panel controls.
Step-by-step guide for recording audio onto a DAT tape.
Instructions for playing back audio from a DAT tape.
Guides for unpacking, connecting components, and setting the unit's clock.
Covers pre-recording considerations, level adjustment, and recording modes.
Functions for locating tracks, repeating tracks, and random playback.
Procedures for writing, positioning, renumbering, and erasing sub codes.
Explanation of the SBM function and the Serial Copy Management System.
Steps for removing the front panel and mechanism deck block.
Procedures for removing the drum assembly, MD board, and reel motor.
Steps for removing the cassette holder, loading motor board, and capstan motor.
Covers preparation, test modes, guide, end sensor, and torque adjustments.
Detailed procedures for mechanical and electrical adjustments including torque and RF waveforms.
Procedures for clock IC back-up check and battery replacement.
Pinout and description for main microcomputer, DSP, and display control ICs.
Pinout and description for mechanism microcomputer and other miscellaneous ICs.
System control/power and audio section block diagrams.
Layouts for audio, digital, display, drum drive, and RF amp sections.
Detailed circuit diagrams for audio, digital, display, drum drive, and RF amp sections.
Block diagrams for ICs in the display, drum drive, RF amp, and audio sections.
Exploded views of the main chassis and front panel components.
Exploded views detailing the cassette compartment assembly.
Exploded views of the mechanism deck sections.
List of capacitors, transistors, ICs, and connectors with part numbers.
List of resistors and switches with part numbers.
List of components for digital, display, and drum drive sections.
List of screws, fuses, and fasteners with part numbers.