Do you have a question about the Sony DVCAM DSR-30 and is the answer not in the manual?
video input composite | 1.0Vp-p, 75Ω, Sync negative |
---|---|
S-Video Y | 1.0Vp-p, 75Ω, Sync negative |
S-Video C | 0.286Vp-p, 75Ω |
video output composite | 1.0Vp-p, 75Ω, Sync negative |
audio input level | 2Vrms (full bit) |
audio output level | 2Vrms (full bit) |
i.LINK DV In/Out | IEEE1394 based (4-pin x 1) |
LANC | Stereo mini-mini jack x 2 |
headphone jack | Stereo mini jack x 1 |
microphone input | Mini jack x 1 (low impedance) |
Control S input | Mini jack x 1 |
Control S output | Mini jack x 1 |
trigger input | Phono jack x1 (active short) |
video signal standard | EIA standards, NTSC color |
---|---|
tape speed DVCAM mode | Approx. 28.193mm/sec. |
tape speed DV SP playback mode | Approx. 18.79mm/sec. |
maximum recording time | 184 minutes (with PDV-184ME) |
tape rewind time | Less than 2 minutes with PDV-184ME |
search speed | -2, -1, -1/5, Still, 1/5, x1, x2, Cue/Review (10 or 15 times) |
operating temperature | 5˚C to 40˚C (41˚F to 104˚F) |
---|---|
storage temperature | -20˚C to 60˚C (-4˚F to 140˚F) |
power requirement | AC 120V, 50/60Hz |
---|---|
power consumption | 32W |
dimensions | 430 x 129 x 374 mm (17 x 5 1/8 x 14 3/4 inches) |
---|---|
mass | Approx. 9.2kg (20 lb 5 oz) |
Essential safety precautions and installation guidelines for VCR operation.
Details on compatible color systems and owner record section.
Notes on video cassettes and recording/playback procedures.
Index to main unit and remote commander components.
Identification and function of front panel controls and indicators.
Details on the detachable operation panel and its controls.
Description of rear panel input/output jacks and switches.
Explanation of indicators and information shown in the display window.
Identification and function of remote commander buttons.
Battery installation and COMMAND MODE selector settings.
Overview of VCR menu structure and procedure for setting the clock.
Procedures for erasing cassette memory and adjusting Y/C delay.
Details on configuration settings in the Setup Menu.
Instructions for setting up timer recordings on the DSR-30P model.
How to use the shuttle ring and jog dial for different playback speeds.
Methods for searching recordings using index, date, or photo search.
How to display camcorder data recorded on the tape.
How to play back video recorded in wide mode.
How to set up automatic tape playback repetition.
How to set up automatic playback of a single program.
Procedure for recording using an external AC timer.
Step-by-step guide to setting date, start, and stop times for recording.
How to check, change, or cancel programmed timer settings.
Introduction to synchronized editing, duplicating, and assemble editing.
How to insert video or audio into existing recordings.
How to connect and use the LANC jack for editing control.
Explanation of time codes, drop frame, and non-drop frame modes.
Connecting to digital video equipment via DV connector.
Connecting to video equipment without DV jacks using analog inputs.
Preparing the source VCR for editing operations.
Preparing this VCR as the recording machine for editing.
Step-by-step guide to synchronizing recording and playback.
How to copy tapes while preserving time code information.
Procedure for selecting and defining events for assemble editing.
How to initiate the assemble editing process.
Locating edit points and preparing the VCR for insert operations.
Steps for executing video, audio, or combined insert edits.
Connecting editing controllers, digital SEGs, and titlers.
Setting up multi-unit tape duplication systems.
Essential warnings regarding unit placement, environment, and handling.
Guidelines for cleaning and maintaining the VCR's cabinet finish.
Procedure for cleaning video heads to ensure optimal picture quality.
How to clean cassette terminals to prevent VCR malfunctions.
Guidelines for handling the unit in environments prone to moisture condensation.
Solutions for problems related to power and cassette insertion/ejection.
Troubleshooting steps for picture display and connectivity issues.
Remedies for sound problems, skipped playback, and missing audio.
Solutions for tape ejects during recording/pause and display errors.
Solutions for issues where the remote commander does not function.
Correcting unintended operation of other equipment by the remote.
Technical details on recording format, video signal, and audio inputs/outputs.
Information on power requirements, operating conditions, and physical dimensions.
Comparison of DVCAM and DV format characteristics.
Guidelines on using DVCAM/DV cassettes and playback compatibility.
How edited tape formats are defined based on recorder format.
Constraints and solutions for editing DV-formatted tapes with DVCAM equipment.
Explanations of various messages appearing on the monitor screen.