7
Getting Started
Unpacking
Check that you have the following items:
• Audio/video connecting cord (1)
• S video cord (1)
• Remote commander (remote) RMT-D113P (1)
• R6 (Size AA) batteries (2)
Inserting batteries into the remote
You can control the player using the supplied remote.
Insert two R6 (Size AA) batteries by matching the + and –
on the batteries. When using the remote, point it at the
remote sensor g on the player.
z
You can control TVs and AV receivers using the supplied
remote
See page 71.
Notes
• Do not leave the remote in an extremely hot or humid place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or lighting
apparatuses. Doing so may cause a malfunction.
• If you will not use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
Transporting the player
Before transporting the player, follow the procedure
below to return the internal mechanisms to their original
positions.
1 Remove all the discs from the disc slots.
2 Close the front panel.
Make sure that “NO DISC” appears in the front panel
display.
3 Wait for 10 seconds, then press 1/u to turn off the
player.
Getting
Started
This section describes how to hook up
the CD/DVD player to a TV (with
audio/video input jacks) and/or an
AV receiver (amplifier). You cannot
connect this player to a TV which
does not have a video input
connector. Be sure to turn off the
power of each component before
making the connections.
To Next Page
Loading...
