To Next PageTo Next Page
Need help?Do you have a question about the Sony EVI-H100V and is the answer not in the manual?
General| Megapixel | - MP |
|---|---|
| Digital zoom | 12 x |
| Optical zoom | 20 x |
| White balance | Auto, Indoor, Manual, Outdoor, Push |
| Camera HD type | Full HD |
| Zoom capability | Yes |
| Focus adjustment | Auto/Manual |
| Operating voltage | 12 V |
| Focal length range | 4.7 - 94 mm |
| Maximum frame rate | 60 fps |
| Camera shutter speed | 1 - 1/10000 s |
| Minimum illumination | 0.5 lx |
| Supported video modes | 1080p |
| Maximum video resolution | - pixels |
| Viewing angle, horizontal | 55.4 ° |
| Power consumption (typical) | 11 W |
| Resolution at capture speed | 1440x1080@25fps, 1920x1080@25fps, 1920x1080@30fps |
| Signal-to-Noise Ratio (SNR) | 50 dB |
| Pan range | -170 - 170 ° |
| Pan speed | 100 °/sec |
| Sensor type | CMOS |
| Mounting type | Clip |
| Product color | Black |
| Built-in flash | No |
| LED indicators | Power, Stand-by |
| Tilt angle range | -20 - 90 ° |
| Built-in microphone | - |
| Optical sensor size | 1/2.8 \ |
| Storage temperature (T-T) | -20 - 60 °C |
| Operating temperature (T-T) | 0 - 40 °C |
Weight and Dimensions| Depth | 164 mm |
|---|---|
| Width | 145 mm |
| Weight | 1550 g |
Emphasizes risks of electrical products and the importance of reading the manual for safe operation.
Covers environmental, servicing, power safety, FCC, ICES-003, and European/ANZ warnings.
Specifies power requirements and prohibits residential use for the apparatus.
Covers location, ventilation, and transportation to prevent damage and ensure proper function.
Advises caution regarding laser beams potentially damaging CMOS image sensors.
Details Exmor CMOS sensor, 20x zoom, dynamic range, HD/analog outputs, and VISCA control.
Identifies the lens, remote sensors, POWER lamp, and STANDBY lamp.
Details rear connectors (VISCA, VIDEO OUT, DC 12V) and switches (IR, SYSTEM SELECT).
Explains the function of each BOTTOM switch for video format, Baud rate, and VISCA control.
Troubleshoots problems with the picture not displaying on the video monitor.
Addresses issues where VISCA control is unavailable with a connected computer.
Provides solutions for when the camera cannot be operated at all.
