Sony FS700 - Odyssey Configuration for 4:2:2 ProRes

[14]
Convergent-Design.com
FS700 4:2:2 to Apple ProRes Recording
Odyssey Conguraon
1. SET ODYSSEY TO HD->HD APPLE PRORES 422 MODE
☼ » SETUP » CAMERA » SONY FS7/FS700 » HD->HD PRORES(.MOV)
2. MAKE FS700 THE RECORD TRIGGER
☼ » SETUP » RECORD TRIGGER » CAMERA
3. SET TIMECODE SOURCE
☼ » SETUP » TIMECODE SOURCE » SDI/HDMI
4. SET PRORES BITRATE
☼ » SETUP » VIDEO CODEC » (SELECT)
PRORES HQ


• 
• 
PRORES 422

• 
• 
PRORES LT

• 
• 
5. FORMAT SSDs
☼ » ODYSSEY » SSD’S » FORMAT BOTH
(or FORMAT SSD1 if you do not have a second SSD drive installed.)
6. CONNECT TO CAMERA AND VERIFY STATUS INPUT
Connect FS700 3G-SDI output to Odyssey SDIA input

Use only 3G-SDI rated cables from FS700 to Odyssey. Using a 1.5G SDI cable in not recommended
and may cause issues.
The status on your Odyssey will display your camera’s output.
Example:
1920x1080
29.97
HD
PRORES