Sony FS700 - LUTs and Import Settings

[19]
Convergent-Design.com
Post Producon
Example LUTs
                


*Also note that using camera metadata or CinemaDNG default is also supported.
To Load 3D LUTs into Davinci Resolve
1. Select the Project Settings wheel, and navigate to Look Up Tables
2. Select Open LUT Folder, and copy the included example LUTs into this folder.
3. Now Select Update Lists
4. Now in the Media Browser you can right click on your RAW le and select 3D LUT and select the LUT you wish to
apply from the list.
Note the following about each CD example LUT, and you should adjust the LUT based on your applicaon.
FS700_1.11.100_SLOG.cube
(Same LUT is recommended with rmware v2.10.141/3.10.100)


FS700 FCP X Import Sengs

1. Under Final Cut Pro select Preferences
2. Be sure the Still Images editing duration is set to 0.0.1 Seconds
3. Select navigate to File and select Import Media
4. Navigate to the Clips directory, and select the Clip Folder contain your FS700 RAW les.
5. At this point you can start correcting the les to a 2.2 Gamma using the Color Board.
* Note if you are recording the internal media you can import the matching S-Log2 le, and select Match Color for a close
approximaon of S-Log2, but will most likely need addional tweaking.