Sony FS700 - FS700 RAW Recording Configuration; FS700 Camera Setup for RAW

[4]
Convergent-Design.com
4K/2K RAW Recording
FS700 Conguraon
1. SET UP THE FS700 FOR RAW RECORDING
MENU » REC/OUT SET » REC SET » RAW SET
Select any of the following frames rates that you wish to record on the Odyssey:
NTSC
4096x2160/24p
4096x2160/30p
4096x2160/60p
2048x1080/24p
2048x1080/30p
2048x1080/60p
PAL




Once the selection is made you will need to press EXEC on the camera, to return to live record.
2. SET GAMMA (REQUIRED FOR RAW RECORDING)
PICTURE PROFILE » PP7 » SETTING » GAMMA » S-Log2
PP7 is the default prole for S-Log2, Note that only S-Log2 is supported when recording RAW.
Once the camera is set to the desired frame rate, then connect to the Odyssey.
3. SET THE S&Q BUTTON FOR RAW HIGH SPEED
MENU » OTHERS » RAW S&Q BUTTON SET » 4K/2K SUPER SLOW
(BACK) » REC Command » ON
NOTE: In 4K Super Slow the camera only outputs a maximum of 4K 60p, thus this mode will use
internal buffering, and then will need to playback the footage to an Odyssey. In 4 Super Slow, the
Odyssey Trigger must be set to Camera.
MENU » RECORD » TRIGGER » CAMERA
NOTE: For 2K up to 240fps sustained, or 4K up to 60p sustained, but 4K 100/120 3-4 second
burst.