28
GB
“PARTY” and “CHAIN” are flashing in
the display panel.
• AUDIO IN function is selected during
Party Chain function. Press
FUNCTION +/– repeatedly to select
other function.
• Restart the system.
Party Chain function does not operate
properly.
• Turn off the system. Then, turn on the
system and activate the Party Chain
function.
To reset the system
If the system still does not operate
properly, reset the system to factory
default settings.
Use the buttons on the unit to perform this
operation.
1 Unplug and plug the power cord
back in.
2 Press ?/1 to turn on the system.
3 While holding down x, press
FUNCTION for about 3 seconds.
“RESET” appears in the display panel.
All user-configured settings, such as
preset radio stations, timers, and the
clock are reset to factory default
setting.
Messages
One of the following messages may
appear or flash in the display panel during
operation.
CHILD LOCK
The child lock function has been enabled.
CONNECT
The system is connecting to the last
connected device during Bluetooth
function.
ERROR
The USB device could not be recognized
or an unknown device is connected.
GUEST
The system becomes a Party Guest when
Party Chain function is activated.
HOST
The system becomes a Party Host when
Party Chain function is activated.
NoDEVICE
No USB device is connected.
NO TRACK
No playable file is loaded in the system.
NOT SUPPORT
An unsupported USB device is connected,
or the USB device is connected through a
USB hub.
PAIRING
The system is in pairing mode.
READING
The system is reading information of the
USB device. Some operations are not
available.
TIME NG
The on time and off time of Play Timer
are the same.
Precautions
On safety
• Completely disconnect the power cord (mains
lead) from the wall outlet (mains) if it is not
going to be used for an extended period of
time. When unplugging the unit, always grip
the plug. Never pull the cord itself.
• Should any solid object or liquid get into the
system, unplug the system, and have it
checked by qualified personnel before
operating it again.
• (For the customers in the USA)
One blade of the plug is wider than other for
the purpose of safety and will fit to the wall
outlet only one way. If you are unable to insert
the plug fully into the outlet, contact your
dealer.
• AC power cord must be changed only at the
qualified service shop.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
