Sony GV-HD700 - Note for Repair

2-1
2. DISASSEMBLY
GV-HD700/HD700E_L2
NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, don’t pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, don’t press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
Tweezers etc.
Harness
(coaxial cable)
When disconnecting the harness (coaxial cable), do not pull th
e
harness part but pull off the connector body with tweezers etc.
NOTE FOR DISCONNECTION THE HARNESS (COAXIAL CABLE)