1-2
HVR-M10C/M10E/M10J/M10N/M10P/M10U
ENGLISH JAPANESE
ENGLISH JAPANESE
2. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V),
the power is shut off so that the unit cannot operate.
This following two methods are available to prevent this.Take note of which to use during repairs.
Method 1.
Use the AC power adaptor.
Method 2.
Connect the servicing remote commander RM-95 (J-6082-053-B) to the LANC jack,and set the commander switch to the “ADJ” side.
3. TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
1 Remove the power supply (Battery and AC power adaptor).
2 Remove the bottom cabinet.
3 Disconnect the CN202 (27P, 0.3mm) of MR-048 board.
4 Remove the top cabinet.
5 Supply +4.5V from the DC power supply to the loading motor and unload with pressing the cassette compartment.
DC power supply
(+ 4.5V)
MR-048 board
CN202
To Next Page